Programming The Short-Time Timer; Programming The Slow-On Timer; Programming The Slow-Off Timer; Deactivating The Timer Function - Conrad FS20 DI20-3 Notice D'emploi

• Programming the short-time timer

Proceed as shown under b), items 1, 2, 3.

• Programming the slow-on timer

Initiate and finalise the programming of the timer as described above.
To assign the programmed time to the slow-on timer, shortly press the On (Ein) button of the
pair of buttons on the remote control during timing.

• Programming the slow-off timer

Initiate and finalise the programming of the timer as described above.
To assign the programmed time to the slow-off timer, shortly press the Off (Aus) button of
the pair of buttons on the remote control during timing.
c) Deactivating the timer function
• Hold down both buttons of the pair of buttons assigned to the wireless dimmer for 1 to 5
seconds simultaneously.
• The pilot LED of the wireless dimmer starts flashing.
• Now press the push button on the wireless dimmer. The pilot LED of the wireless dimmer
goes off.
The timer function has been deactivated.
d) Controlling the wireless dimmer while timer is active

• Slow-on/slow-off function

If you turn the wireless dimmer on or off by shortly pressing a button (on the remote control
or on the device itself), the wireless dimmer will, over the programmed time, gradually adjust
the brightness to the value saved before the timer was started.
If the same command is given during the dimming process, the saved brightness will be set
immediately.
When dimming manually (by holding down the button), the timer does not become active.
(Make sure you do not hold down the button on the wireless dimmer for more than 15
seconds, as this will activate programming mode.)
The timer mode will be active at the next regular switching command (by shortly pressing the
button).
39