Legrest Adjustment/Removal; Split Option; Angle Adjustment; Removing The Leg Stem - Zippie Pluton 1 Notice D'utilisation

20.0 Legrest Adjustment/Removal

Split Option:

NOTE: When fitted with Split Leg Stems/Footplates, it is
possible to set the angle for both left and right stems
independently. To do this follow the instructions below for
each leg stem.

Angle Adjustment

• Pull and Hold Out plunger A with one hand before
adjusting the legrest angle with your other hand to the
desired angle.
• When you have achieved the desired position, release
the plunger to secure in the next available locking
position.
• Ensure the plungers are securely located in position.

Removing the Leg Stem

Facilitates Standing Transfer.
NOTE: Removal of the Footplates can also help when
packaging for transportation or when the seat is to be
utilised on a chassis with its own integrated footplates.
• To Remove the Leg Stems Entirely (complete with the
attached footplate), remove safety boss B using the
4mm Allen Key Provided.
• Once removed, Pull and Hold Out Plunger A with one
hand, using your other hand to rotate and pull away
the Leg Stem entirely from the main seating unit.
• To replace, reverse the operation, locating the leg
stem onto the fixation Hook C, holding open the
plunger to allow it to engage fully before releasing the
plunger to lock the leg stem into position.
• Finally refit the safety boss using the 4mm Allen Key
provided.
Pluton Rev.2.0
Fig.20.1
Fig.20.2
D
A
B
25