Lever Use-Using Index Plungers; Using The Index Plungers (Locking Variety Only); Adjusting Shoulder Protector Pads; Pad/ Shoulder Width - Zippie Pluton 1 Notice D'utilisation

7.0 Lever Use-Using Index Plungers

Using The Index Plungers
To place the plungers in an open position:
• Pull out the plungers to maximum tension (B).
• Turn the plungers a half turn anti-clockwise (C) This
places them in an open position.
• To close - Turn the plungers a half turn clockwise and
they should snap back into a locked position (A).

8.0 Adjusting Shoulder Protector Pads

Pad/ Shoulder Width

Turn locking screw (A) half a turn using the 4mm Allen
Key provided, manually position the pad to fit the user by
sliding the pad in or out.
Lock the pad in place by re-securing locking screw A.

Pad/Protraction Angle

To set the angle of the pad you should loosen the
securing handwheel (B) by rotating a couple of turns in an
anti-clockwise motion. Once released the pads can be
positioned by pressing down on the handwheel whilst
simultaneously altering the angle of the pad using your
other hand.
Once the desired position has been achieved you should
release the handwheel and resecure it by turning in a
clockwise direction until hand tight.
CAUTION!
Pad Angle – As an Alternative you can position the pad
without pressing down the handwheel, though this has
potential to shorten the life of the locking mechanism and
is therefore not recommended.
14
(locking Variety Only)
Fig.7.1
A
LOCKED
Fig.7.2
B
PULL
Fig.7.3
C
OPEN
Fig.8.1
B
A
Pluton Rev.2.0