Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
19.0 Arm Rest Adjustment
Adjusting Arm Height
•
(A) highlights the plunger which is used to adjust the
height of the arms and therefore in turn the height of
the tray.
•
Pull plunger (A) outwards away from the arm, and
while holding the lever open slide the arm up or down,
selecting one of the holes which come into view as
you raise the arm up from its lowest position.
•
When a suitable position has been acquired, lock the
arm into place by releasing the lever, ensuring it fits
securely back in place.
Adjusting Arm Angle
•
To set the angle of the arm top you should loosen the
securing handwheel (B) by rotating a couple of turns
in an anti-clockwise motion.
•
Once released the arm top can be positioned by
pressing down on the handwheel whilst
simultaneously altering the angle using your other
hand.
•
Once the desired position has been achieved you
should release the handwheel and re secure it by
turning in a clockwise direction until hand tight.
CAUTION!
The plunger (A) should pull out freely, if resistance is felt
ensure no weight is being put through the arm rest.
Removing The Armrest
(Facilitates Side Transfer)
•
To remove the arm rests entirely (complete with the
attached hip pad), pull plunger (C) outwards and hold
in the outward position with one hand. Use your other
hand to lift the complete arm rest assembly upwards
away from the seat.
•
To replace, reverse the operation, lowering the arm
rest assembly back onto the fixation plate (D), holding
open the plunger to allow it to engage fully before
releasing the plunger to lock the arm back into
position.
WARNING!
Always ensure that the arms are securely fixed before
using the chair.
CAUTION!
Arm Top Angle – As an Alternative you can position the
Arm Top without pressing down the handwheel, though
this has potential to shorten the life of the locking
mechanism and is therefore not recommended)
24
Fig.19.1
B
Fig.19.2
A
C
D
Pluton Rev.2.0
Publicité
Chapitres
Table des Matières
