5-Star Base Adjustment; To Raise The Chair; To Lower The Chair; To Perform The Tilt In Space On The 5 Star Base - Zippie Pluton 1 Notice D'utilisation

12.0 5-Star Base Adjustment

WARNING!
Always ensure the base is stable and that the brakes are
applied before performing the following adjustments.
Refere to Fig.12.1.

To Raise The Chair

Located at the back of the chair beneath the base locate
the handle (A) and continuously push down to raise the
height.
The seat height will raise with additional assistance
required, dependent upon the weight of the user.
Release the handle when the desired height is achieved.

To Lower The Chair

Use the handle (A) again but this time apply pressure to
the top of the seat with one hand whilst pushing down
handle (A).
CAUTION!
If you find performing these actions difficult to do
simultaneously on your own please get another person to
help you.

To Perform the Tilt in Space on the 5 Star Base

Refere to Fig.12.2-12.3
• Lift safety latch (B) up to prepare the base for the tilt
adjustment.
• Lift operation latch (C) up until it stops, disengaging
bar (D).
• Tilt the base interface to the desired angle.
The adjustment range can be seen via the groove at
the side of the seat base.
When the desired angle has been achieved. Close
operation latch (C) by pushing down until it bar (D)
locates securely into a set position groove (F).
• Push down safety latch (B) to prevent accidental
operation of the tilt in space.
• Always ensure that the groove on the safety latch (B)
is securely located onto the bar (D) to secure the seat
into place.
18
Fig.12.1
Fig.12.2
D
Fig.12.3
F
D
B
C
A
B E
C
D
B
Pluton Rev.2.0