Harness And Lap Strap Positioning - Zippie Pluton 1 Notice D'utilisation

Tightening the belt:
Keep belt tightened at adjustment straps during fitting
and daily use to ensure correct pad placement. For
padded hip belts the pads are to be touching when
correctly tightened. For non-padded hip belts the
adjustment strap at the buckle should be approximately
3" (76mm) long. Education of the care giver is essential
for correct hip belt positioning.
Fig.5.5
All straps &
harnesses must be
securely fitted to the
back of the chair.
Primary Lap Strap
Fitting
12
Chest Harness
Fitting
Secondary lap strap fitting
(four-point lap strap)
Sizing:
Measure hip width to determine the belt size required.
The suggested method for measuring hip width is from
trochanter to trochanter. If this is not possible, measure
from ASIS to ASIS and add a couple of inches. The
correct belt size for the individual has padding that covers
all of the bony prominences.
• Always check that the child's pelvis is symmetrical and
positioned securely at the back of the seat.
• Always ensure that the lap straps and chest harness
hold the child securely and are comfortable. Ensure
they provide a snug fit, a simple rule of thumb is to
allow two fingers to be inserted between the belt and
the childs body.
• Never leave a child in a chair unattended without the
lap strap being fastened.
• A lap strap should always be fitted if a harness is
being used.
• When altering the angle between the seat and the
back of the chair always re-adjust the chest harness
and lap strap accordingly to ensure all safety
recommendations are followed.

Harness and Lap Strap Positioning

This diagram below shows the recommended positioning
of the chest harness and lap straps, (Fig.5.1):
The cross strap on the
chest harness must be
fitted no higher than the
sternum (mid chest).
Primary Lap Strap Fitting
Pluton Rev.2.0