Seat Unit; Mounting - Zippie Pluton 1 Notice D'utilisation

9.0 Seat Unit

Mounting

WARNING!
Always ensure the base is stable and that the brakes are
applied before mounting the seating unit.
CAUTION!
Please note that the handle fitted is dependent on the
size of the chair. You therefore need to ensure the size
label on the handle matches the size of the chair being
used.
See, (Fig.9.1-Fig.9.2).
• There are 2 cut outs on the top of the interface plate
(A) which are for locating lugs (B) on the seating unit
to fit into.
• Position the seating unit above the interface plate,
lining up the locating lugs (B) with the cut outs (A) on
the interface plate.
• Carefully lower the seat onto the interface plate
ensuring the locating lugs (B) slide into the cut outs on
the interface plate (A).
• Push the seating unit inwards towards the back of the
chair until the locating lugs 'click' into place.
• Ensure the seat is securely located on the base before
using.
View from the side showing the seating unit lugs lowering
into the interface plate cut outs, (Fig.9.3).
View of seat engaged with the base (Fig.9.4).
Pluton Rev.2.0
Fig.9.1
B
Fig.9.2
Fig.9.3
Fig.9.4
A
15