Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
17.0 Headrest Adjustment
Adjusting The Wing Angle
This adjustment point allows you to move the wing
position to offer more side support to the head. This
adjustment point allows you to alter the angle of the
headrest to support the head and neck.
•
Unzip the headrest cover at the back and loosen the
lock lever (A).
•
Adjust the sides of the headrest into the desired
position.
•
After desired position has been reached tighten the
bolts to secure in place.
Perform this for either side wing of the headrest.
Adjusting the Headrest Angle
•
Levers (B) should be operated together to achieve the
desired head positioning of the user. Loosen the
levers by turning anti-clockwise.
•
Once loose, the head support angle can be manually
adjusted to suit the user.
•
Tighten the levers to secure in place.
Adjusting the Headrest Height
•
Loosen the hand wheel (C)
•
Slide the headrest up or down inside the bracket on
the back of the chair.
•
Re tighten the hand wheel to secure in place.
WARNING!
Always check that the headrest is secure and the wings
are not tight around the head. The headrest wings are
ideally set at 45 degrees to the back.
18.0 Lateral Support Adjustment
Height & Width of Supports
•
Loosen both bolts (A) using the allen key provided.
•
Slide the pads up or down along the slot in the seat
back (B) to adjust the height.
•
Slide the pads horizontally to adjust the width.
•
Re tighten the allen key bolts to secure.
Flip Away Action (Where Fitted)
•
Pull plunger (C) downwards.
•
Flip the supports away to aid transfer or set up.
•
When ready push the supports back in, until they lock
in place.
WARNING!
Check that the supports are not too high under the arms
of the user or tight around chest area by running your
fingers around the inside of the supports. Also check that
the supports do not infringe on any feeding tubes.
Pluton Rev.2.0
Fig.17.1
C
B
Fig.18.1
C
B
A
A
23
Publicité
Chapitres
Table des Matières
