Charging the battery (fig. 71)
Before charging the battery, it is best to remove it from
the motorcycle.
Remove the r.h. side fairing (see page 62), undo the
screw (1) and remove the upper bracket.
Always disconnect the black negative terminal (-) first,
and then the red positive terminal (+).
Warning
E
Batteries develop explosive gases: keep it away
from heat sources.
Charge the battery in a ventilated room.
Connect the battery charger leads to the battery
terminals (red to positive terminal +, black to negative
terminal -).
Important
Make sure the charger is off when you connect the
battery to it, or you might get sparks at the battery
terminals that could ignite the gases inside the cells.
Always connect the red positive (+) terminal first.
Reinstall the battery on its mount and secure the upper
bracket with the screw (1). Apply some grease on the
fastening screws to improve conductive capacity and
connect the terminals.
70
All manuals and user guides at all-guides.com
Charge the battery at 1 A for 5-10 hours.
Warning
Keep the battery out of the reach of children.
-
1
+
fig. 71