Fade In/Out Functions - Panasonic Palmcorder MultiCam PV-GS50 Manuel D'utilisation

W.B / SHUTTER / IRIS
PUSH
1
MF / VOL / JOG
PHOTO
2
SHOT
EIS
PHOTO
2
SHOT
1, 3
FADE
1
2
Digital Electronic Image Stabilizer
Function
If you are recording in unstable situations and the Palmcorder is
shaky, you can use this function to correct for camera shake in these
images.
≥If the Palmcorder shakes too much, this function may not be able to
stabilize images being recorded.
1
Set [CAMERA FUNCTIONS] >> [CAMERA SETUP] >>
[EIS] >> [ON].
≥The [EIS] Indication
2
Press the Recording Start/Stop Button or
[PHOTO SHOT] Button to start recording.
Canceling Digital Electronic Image Stabilizer
1
Set [EIS] on the [CAMERA SETUP] Sub-Menu to [OFF].
≥For other notes, see page 86.
~~~~~~~~~~~~~~~~~~~~~~

Fade In/Out Functions

2
1
Fade In
Fade In brings out images and sounds gradually from a black screen
at the beginning of a scene.
1
Hold down the [FADE] Button while the Palmcorder
is set to the Recording Pause Mode.
≥The image fades out gradually.
2
When the image is completely gone, press the
Recording Start/Stop Button to start recording.
3
Release the [FADE] Button about 3 seconds after
starting recording.
≥The image reappears gradually.
Fade Out
Fade Out causes images and sounds to disappear gradually,
leaving a black screen at the end of a scene.
1
Hold down the [FADE] Button while recording.
≥The image fades out gradually.
2
About 3 seconds after the image is completely gone,
press the recording Start/Stop Button to stop
recording.
3
Release the [FADE] Button.
≥Fading-in and fading-out cannot be used when recording still
pictures in the PhotoShot Mode, Digital Still Picture Mode,
Multi-Picture Mode, and for the small still picture in the
Picture-in-Picture Mode.
1
appears.
2
32