Image Stabilizer Function
If the Camcorder is shaken while recording, the
camera shake in the image can be corrected.
≥If the Camcorder shakes too much, the images
may not be stabilized.
1
Set [TAPE RECORDING MENU] >>
[CAMERA] >> [EIS] >> [ON].
STILL
ENTER
s
i
FADE
(14)
MENU
≥The [EIS] Indication appears.
2
Press the Recording Start/Stop Button
or [PHOTO SHOT] Button
recording.
PHOTO
SHOT
(47)
(42)
To Cancel Image Stabilizer Function
Set [TAPE RECORDING MENU] >> [CAMERA]
>> [EIS] >> [OFF].
≥For other notes concerning this item, see
Fade In/Out Functions
Fade In
Fade In brings out images and sounds gradually
from a black screen at the beginning of a scene.
1
Keep pressing the [FADE] Button
during the Recording Pause Mode.
STILL
s
ENTER
i
(18)
FADE
≥The image fades out gradually.
Recording Mode
EIS
(42)
(47)
to start
.
-73-
(18)
-33-
2
When the image is completely gone, press
the Recording Start/Stop Button
start recording.
(42)
3
Release the [FADE] Button
3 seconds after starting recording.
≥The image reappears gradually.
Fade Out
Fade Out causes images and sounds to
disappear gradually, leaving a black screen at the
end of a scene.
1
Keep pressing the [FADE] Button
recording.
STILL
s
ENTER
i
(18)
FADE
≥The image fades out gradually.
2
When the image is completely gone, press
the Recording Start/Stop Button
recording.
(42)
3
Release the [FADE] Button
≥The still picture cannot fade in or fade out.
Backlight Compensation Function
This prevents the subject from being recorded too
darkly when backlit. (Backlight is the light that
shines from behind the subject being recorded.)
1
Press the [BACK LIGHT] Button
BACK LIGHT
(8)
(42)
to
(18)
about
(18)
while
(42)
to stop
(18)
.
(8)
.