Use; Leg Training; Arm Training; Display Functions - Crivit 340668 1910 Notice D'utilisation

Use

Stand the product in front of you to begin train-
ing. Begin with gentle training and resistance. To
do this, release the resistance screw. The tighter
the resistance screw is turned, the more difficult
it is to turn the pedals. Warm up before each
training session with stretching and warm-up
exercises. Relax after each training session.
Leg training (Fig. J)
1. Place the product on a level, stable and
smooth floor and sit relaxed and upright in
front of the product on a chair, with a straight
back.
Note: make sure the chair is stable and com-
fortable.
2. Place your feet on the pedals, so that the
pedal straps go over your feet.
3. "Cycle" with your feet.
4. You can pedal backwards as well as forwards.
Arm training (Fig. K)
1. Place the product in front of you on a level,
stable and smooth surface (e.g. at table
height) and sit relaxed and upright on a chair,
with a straight back.
2. Lay your palms on the pedals, so that the
pedal straps go over your hands.
3. "Cycle" with your hands.
4. You can pedal backwards as well as forwards.

Display functions

The two-line display has different modes. The top
line shows the speed (km/h) and by pressing the
button, the bottom line can display the following
functions:
• TIME: in this mode the length of your actual
training is displayed in minutes and seconds.
• Speed: in this mode your speed (km/h) is
displayed.
• ODO: in this mode your total distance (km)
since inserting the battery is displayed.
• RPM: in this mode the pedal rotations per
minute are shown.
• DISTANCE: in this mode the distance cov-
ered in kilometres since the start of the training
session is shown.
• CAL: in this mode the actual number of calo-
ries you have used during training are shown.
12 GB/IE/NI
All manuals and user guides at all-guides.com
• SCAN: in this mode the various display
modes are alternately displayed.
Note: the calorie use is only an approximate
guide.
Note: when not in use the display automatically
turns itself off after approx. four minutes.
Resetting the value to zero
Press the button for approx. four seconds in
order to reset the value to 0.

Troubleshooting

Defects
Display does not show measurement despite
pedal movement.
Possible cause
The sensor is not placed correctly in the sensor
mount.
Solution
Check that the sensor is positioned correctly if
the display does not show anything even though
the pedals are moving (Fig. H).
1. Open the display as for battery replacement
and carefully remove it.
2. Insert the sensor carefully into the sensor
holder, if it's not correctly seated.
3. Replace the display on the product, making
sure the display button is pointing down.

Storage, cleaning

Clean the product with a damp cloth and a mild
detergent.
Warning! Do not let any moisture enter the
display.
Store the product in a dry place.
Parts prone to wear: if the product no longer has
pedal resistance, the drive belt is worn out. The
product must be replaced.

Disposal

In the interest of protecting the environ-
ment, do not throw your product into the
household waste once you are finished
with it, but rather take it to a specialty disposal
facility. Find out about collection sites and their
hours of operation from your local authority.