Inserting The Batteries; Wall Installation; Private Branch Exchanges - switel TF 52 Mode D'emploi

Les langues disponibles

Putting the Telephone into Operation

Inserting the batteries

Insert the batteries in the open

battery compartment.

Only use batteries of the type

AA 1.5 V. Pay attention to the

correct polarity. Close the

battery compartment cover.

Insertion of batteries is not absolutely essential. The telephone

can be operated with or without batteries. The full range of tele-

phone functions can only be used when batteries or the power

adapter plug are fitted. Pay attention that the telephone is not con-

nected to the telephone line socket and/or mains power connec-

tion when the batteries are being inserted or replaced.

When the batteries are empty, the

Replace the batteries.

Setting the time and date

The time and date are set via the menu. Refer to Page 68 for the se-

quence of menu option selections necessary.

The information on Page 67 explains how to install your telephone in a pri-

vate branch exchange.

All manuals and user guides at all-guides.com

icon appears in the display.

Feed the guide tabs (1) on the wall−mounting bracket (2) in the slots (3) on

the underside of the telephone. Slide the wall−mounting bracket 10 mm

upwards until it audibly locks into place. Drill a hole and insert a screw

leaving about 5 mm of the screw projecting from the wall. Guide the

mounting hole (4) in the mounting bracket (2) over the screw and slide the

telephone downwards.

Caution: Ensure there are no electrical cables, water pipes etc.

in the wall where the hole is drilled.

Turn the hook (5) in the receiver cradle so that the receiver can be placed

on−hook.

Table des Matières