Commissioning; Safety Information; Check Contents Of Pack; Fitting The Batteries - switel T39 clip Mode D'emploi

3

Commissioning

3.1

Safety information

Note! Before commissioning, it is essential that you read the general information at the begin-
ning of this manual.
3.2

Check contents of pack

The following items are supplied:
one telephone base
one telephone connection cable
one desk adapter
four batteries Type AAA
3.3

Fitting the batteries

Before connecting your new telephone to the telephone network, the batteries should be fitted.
Please always use type AAA alkaline batteries. The batteries are required for the call number
display, the handsfree feature and other functions of the telephone. Before installing or changing
the battery, make sure that the telephone is not connected to the telephone network.
Note: No messages will be shown in the display and the handsfree function will not work if the
batteries are not fitted.
1. The battery compartment is to be found on the underside of your telephone.
2. Open the battery compartment with a small screwdriver or a pointed object.
3. Insert the batteries, ensuring that the polarity is correct.
4. Close the battery compartment.
The battery should be changed when the
All four batteries must then be changed so that the call number display and the handsfree
function continue to work correctly.
If the batteries become discharged, the display will go dark and the handsfree function will not
work.
3.4

Connecting the telephone receiver

After unpacking your telephone, you must first connect the telephone receiver to the base unit.
First take the short end of the spiral cable and plug it into the socket at the bottom of the receiver.
Turn the telephone over and plug the long end into the socket marked HANDSET. Feed the cable
through the cable channel to the outside.
3.5

Connecting the telephone

Connect the telephone cable supplied to the telephone socket and the telephone jack marked
LINE" on the underside of the telephone. Then feed the cable out of the telephone housing either
upwards or downwards through the cable guide. Clip the cable firmly in the cable channel.
The telephone works using the tone dialling system.
− Commissioning −
one telephone receiver
one spiral cable
one Operating Manual
J
symbol appears in the display.
59