Flexible Back (Eclips +); Anatomical Back - Vermeiren Eclips+ Mode D'emploi

All manuals and user guides at all-guides.com

FLEXIBLE BACK (ECLIPS +)

The height of the back can be adjusted by setting the entire back tube (see the section on "Pushing
handles").
For adjusting the height of the back cover, loosen the fixing screws behind the back tube. Then you
can move the cover upwards or downwards. There are fixing holes every 0.79 in. in the back tube
where the screws can be retightened. Make sure that all screws are properly tightened before using
the wheelchair.
L
Only your specialist dealer may adjust the height of the back.

ANATOMICAL BACK

A subsequent addition of an anatomical back is not possible for the ECLIPS+30° model.
STEERING WHEEL ADAPTER
The height of the seat can be adjusted in the front axle area. The inclination of the seat can also be
adjusted when setting only the steering wheel adapter.
1
Adjustment of the height and angle of the seat
The steering wheel adapter (2) is situated at the bottom end of the front frame (1). The height of the
adapter can be adjusted after loosening and removing the fixing screws (3). It should be secured
again with these screws. The steering wheel adapter is held in place with special slope nuts (4).
To use the anatomical backrest, proceed as follows:
• Unscrew the flexible backrest.
• Loosely screw on the brackets for the backrest.
• Insert the backrest into the brackets from above.
Tighten the screws holding the brackets for the
•
backrest.
• Insert and tighten the safety screws for the
backrest.
• Add the armrests (see "Armrests" chapter).
L
Use suitable tools (a Phillips screwdriver).
L
Check that the backrest is secure before use.
L
Avoid getting your fingers caught during the assembly
process.
L
Avoid damaging the screws / washers.
3
2
8
Eclips+/Eclips+30°
A B
or
4
E
11/2008