Vermeiren Eclips+ Mode D'emploi page 16

E
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centred properly. If not - let out the air and position the
tyre afresh.
Now the tyre can be inflated to its full operating pressure (note the maximum!!) and the valve cap
should be replaced.
L
When mounting a tyre, make sure that no objects or body parts are pinched between the tyre
and the rim, since that could cause damage and/or injury.
L
Only an expert can guarantee correct assembly. Work not done by your specialist dealer,
would void any warranty claims.
L
When inflating the tyres, always check that the pressure is correct. The correct pressure is
given on the tyre walls (also refer to "Technical details").
L
Use only inflating equipment which complies with regulations and indicates the pressure in
bar, or use the supplied air pump. We do not accept any liability for damage caused by
inflating equipment not supplied by the manufacturer.
All manuals and user guides at all-guides.com
Push the tyre over the edge of the rim, starting behind
the air valve. Inflate the tube slightly until it is round,
and place it inside the tyre.
If the tube fits snugly inside the tyre without any folds
(in the case of folds: let out some air), then the upper
side of the tyre can be pressed lightly onto the rim
with both hands, starting at the air valve.
13
Eclips+/Eclips+30°
11/2008