Exterior Cleaning; Ice Machine Inspection - Manitowoc QM30 Manuel D'installation Et De Service

Maintenance
Step 15 Add the proper amount of Manitowoc Ice
Machine Sanitizer to the water trough.
Model
QM30
Step 16 Wait until the sanitize cycle is complete
(approximately 45 minutes) then place the toggle switch
in the OFF position, disconnect power and water
supplies to the ice machine.
!
Disconnect electric power to the ice machine at the
electric switch box before proceeding.
Step 17 Repeat step 6 to remove parts for hand
sanitizing.
Step 18 Mix a solution of sanitizer and warm water.
Solution Type
Sanitizer
Step 19 Use half of the sanitizer/water solution to
sanitize all removed components. Use a cloth or sponge
to liberally apply the solution to all surfaces of the
removed parts or soak the removed parts in the
sanitizer/water solution. Do not rinse parts after
sanitizing.
Step 20 Use half of the sanitizer/water solution to
sanitize all foodzone surfaces of the ice machine and
bin. Use a cloth or sponge to liberally apply the solution.
When sanitizing, pay particular attention to the following
areas:
• Evaporator plastic parts - including top, bottom and
sides
• Bin bottom, sides and top
Do not rinse the sanitized areas.
Step 21 Replace all removed components.
Step 22 Reapply power and water to the ice machine
and place the toggle switch in the ICE position.
12
Amount of Sanitizer
45 ml
Warning
Water Mixed With
120 ml (4 oz)
23L. (6 gal )
sanitizer

Exterior Cleaning

Clean the area around the ice machine as often as
necessary to maintain cleanliness and efficient
operation.
Sponge any dust and dirt off the outside of the ice
machine with mild soap and water. Wipe dry with a
clean, soft cloth.
Treat all exterior stainless steel surfaces with a
commercial grade stainless steel cleaner/polish.

Ice Machine Inspection

Check all water fittings and lines for leaks. Also, make
sure the refrigeration tubing is not rubbing or vibrating
against other tubing, panels, etc.
Do not put anything (boxes, etc.) in front of the ice
machine. There must be adequate airflow through and
around the ice machine to maximize ice production and
ensure long component life.
Section 4
Part Number 00000xxxx 05/10