Common To All Metallic Fireplace Models; Installation And Safety Instructions - Bronpi LORCA-R Instructions D'installation, D'utilisation Et D'entretien

ATTENTION!!:
It must be taken into account that the ducting pipe for reasons of space can't be placed through the interior of the flue cover. For
this reason, the installer must have this into account as well as the aesthetics to be developed in order to hide (if desired) these
channeling pipes.
Turbine replacement
In case of replacement of one of the electrical components, in the models Lisboa and Lisboa-C,
the replacement process can be carried out without uninstalling the fireplace, as they are placed
under its bottom side. It is possible to access the components through the combustion chamber by
following the next steps (see drawing D2.23).
1. Remove the vermiculite baffle plate.
2. Remove the cast-iron back plates.
3. Remove the cast-iron grate.
4. Remove the screws from the fan support, lift from the left side and remove it, you must do it
carefully because of the cables of the stallation.
In the case of the Lisboa-3C model, the steps would be (see
drawing D2.24):
1. Remove the side cast-iron plates by pulling upwards from
the front.
2. Remove the baffle plate.
3. Remove the cast-iron grate by pulling out from the sides.
4. Remove the screws from the fan support, lift from the left
side and remove it, you must do it carefully because of the
cables of the installation.
Outdoor air intake
In the models of the Lisboa, it is possible to choose that the
entrance of primary air comes from a contiguous place or even
from outside of the house.
In the case of providing air from outside or from a contiguous place, you must purchase the optional kit (KIT-AIR2) for external air intake
(airtight). Simply connect the KIT with a 100 mm diameter pipe to the chosen place. Keep in mind that a too long pipe or with too many
deviations (elbows), far from benefiting the intake of air, causes a great loss of load and, therefore, can cause combustion problems.
Do not forget that this external air intake is independent and different from the input needed for the ventilation unit (turbine), so the decoration
or masonry made to the insert, must have a sufficient air circulation for the flow of the turbine (see drawing D2.25).
The procedure for placing the optional external air intake kit is as follows:
- Position the kit below the plane of fire. You must center the kit and position it on the front (inner face) as indicated in the image.
- With the supplied self-drilling screws, connect the kit to the base of the appliance.
- Connect the air intake to the exterior or selected environment through a 100 mm diameter pipe.
2.1.4.

COMMON TO ALL METALLIC FIREPLACE MODELS

Bottom base / woodshed
At the bottom of the metallic fireplace, except for the Huelva-C models, you will find a space that
can be used as a logger or woodshed. For safety reasons, it is compulsory not to overload this
compartment, so that due to the heat radiation (depending on the load on the combustion chamber -
see table of technical characteristics) it doesn't cause the ignition of the stored firewood. (see drawing
D2.26).
3.

INSTALLATION AND SAFETY INSTRUCTIONS

The way of installing the fireplace will affect the safety and the proper operation. For this reason, it is
recommendable that the installation is carried out by people who are qualified and informed about the
compliance with the installation and safety norms. If a metallic fireplace is not properly installed it
may cause serious damage.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 20
D2.23
D2.24
D2.25
D2.26
METALLIC FIREPLACES