Troubleshooting Guide; Optional Parts Made-To-Measure - Bronpi LORCA-R Instructions D'installation, D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour LORCA-R:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

11. TROUBLESHOOTING GUIDE

PROBLEM
POSSIBLE REASON
The fireplace
Inappropriate use of the fireplace
gives off smoke
Smoke duct is cold
Smoke duct is obstructed
Smoke duct is oversized
Smoke duct is tight
The draw is not enough
Smoke duct with infiltrations
More than one equipment connected to the
duct
Air returns
Inappropriate use of the fireplace
Combustion range too low. Lack of draw
Excessive ash accumulation
The smoke duct does not protrude the top of
the roof
Combustion out
The door is not sealed properly or is open
of control
Excessive draw
Refractory sealing plaster is damaged
Smoke duct is oversized
Strong winds
Green or wet wood with bad quality
Insufficient heat
Green or wet wood with bad quality
Lack of primary air
Smoke duct with air infiltrations
Masonry exterior of the chimney is cold
Heat loss in the house
** The note PROFES means that the task must be done by a professional.

12. OPTIONAL PARTS MADE-TO-MEASURE

Regarding the use of the flue cover, it is necessary to consider:
-
Height, floor-ceiling. Measure it in the central part of the fireplace.
-
Slope of the ceiling. If you stand facing the fireplace, we should indicate:
from left to right
from right to left
from back to front
from front to back
For this reason and to help you during your choice, we can manufacture "special" pieces according to the previous specifications
SOLUTION
Open the primary air intake a few minutes and then open
the door
Pre-heat the fireplace
Check the duct and the connector to see if it is obstructed or
has excessive soot
Install an appropriate diameter
Install an appropriate diameter
Add length to the chimney
Seal connections between sections
Disconnect the rest of equipments and seal the entrances
Open completely the primary air intake and, later, the door
during a few minutes
Use the fireplace with an appropriate range. Increase the
primary air intake
Empty the ash pan frequently
Add length to the chimney
Close the door or change the sealing cords
Check the installation or install a draft-diverter valve
Check the joints and use refractory putty
Install an appropriate diameter
Install an appropriate chimney cowl
Use dry wood. Air dried during at least 1 year
Use dry wood. Air dried during at least 2 years
Increase the primary air intake
Use an insulated system of chimney
Insulate thermally the chimney
Seal windows, openings, etc
D12.1
26
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES
PROFES

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

HuelvaHuelva-cEbroLisboaLisboa-3cHuesca

Table des Matières