Bronpi LORCA-R Instructions D'installation, D'utilisation Et D'entretien page 18

Baffle plate:
The baffle plate is a fundamental part for the proper operation of the fireplace. It must be placed in the right position and the fireplace
must not be used without the baffle plate. This would invalidate the warranty (see drawings D2.4, D2.5 and D2.6).
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a fast combustion, excessive wood consumption and the
overheating of the equipment.
Due to safety reasons during the transport in some models, the baffle plate is not assembled. You will find it inside the combustion chamber.
In order to place it properly, you should follow the next steps:
Frontal models:
D2.7
Moreover, the fireplace includes a metallic flue cover in order to hide the smoke pipes (see drawings D2.8 and D2.9). In no case may this
piece act as smoke pipe. It comprises two parts:
- A fixed part that must be placed on the upper part of the hood:
- A moving part (telescopic) of around 50 cm that is introduced into the
fixed part. This telescopic piece will be extracted until it touches the
ceiling. Then, screw it through the holes.
- The inside part of the combustion chamber is made of detachable cast
iron or vermiculite plates (see drawing D2.10) and the product should
never be used if these plates have been extracted. This fact would
invalidate the warranty.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D2.4 D2.5
D2.6
Barbecue grill
The Huesca model, as well as the models of the series Lisboa, incorporates
as standard a barbecue grill. It is adjustable in two heights depending on the
slot of the lateral guide that you use (see drawing D2.7).
D2.9
D2.8
17
Corner models:
Telescopic
grate
(Moving-
adjustable part)
Chimney trim
Fixed part
METALLIC FIREPLACES
D2.10