Factory Setting; Cleaning And Maintenance; Repair; Firmware Update - Truma iNet Box Mode D'emploi

Factory setting

Reset all settings to the factory setting and delete all individ-
ual data or for a appliance search on the interface TIN2.
Press the button (Figure 2 – 1) for at least 20 seconds.
The blue LED lighting up briefly indicates that the reset has
been completed and the appliance search on TIN2 has been
performed.

Cleaning and maintenance

Clean the appliance only with a slightly moistened, lint-free
cloth.
Do not use any chemical or scouring cleaning agents.
Make sure that no liquids or other components enter the
Truma iNet Box.

Repair

If repairs are necessary, contact Truma Service.

Firmware update

To perform an update, only one mobile terminal device may
be actively connected to the Truma iNet Box.
An available firmware update for the Truma iNet Box is dis-
played in the Truma App on the mobile terminal device or can
be called up manually via the settings. Transmission is via
Bluetooth (follow the instructions in the Truma App).
The battery of the mobile terminal device must be sufficiently
charged before a firmware update.
22
The mobile terminal device should not be moved or used
during an update.

Disposal

The appliance must be disposed of in accordance with the ad-
ministrative regulations of the respective country in which it is
used. National regulations and laws (in Germany, for example,
the End-of-life Vehicle Regulation) must be observed.

Accessories

TIN-bus cable, 3 different lengths
12 / 24 V connector cable
Fuse holder with 1 A fuse
TIN distributor