Rizzoli S 60 CF Manuel D'utilisation page 64

4.8 MAINTENANCE OF THE LIGHT
WARNING! Before starting any maintenance operation for the light, you must
disconnect it from AC power and be sure that the cooker is not powered. Verify
also if the cooker is cold and if the light was turned on in the previous minutes.
Oven lamp suffers high temperatures. Even
if it is designed to work in these conditions,
it could become out of order. You have to
replace it with a lamp with the same fea-
tures (halogen lamp 25W 230V 300° connec-
tion G9).
To replace the lamp you have to unscrew
the lamp cover, remove the lamp, insert the
new lamp and finally screw in the lamp cov-
Picture 25 - Oven lamp disassembly
4.9 CLEANING THE OVEN LAMP COVER
Sporadically, with cold cooker, unscrew the
lamp cover and remove the external residu-
als due to cooking steams. Dry with care the
lamp cover and screw it in its placing. Before
WARNING! the device must be disconnected from AC power before you start
the unscrewing of the lamp cover!
4.10 REPLACEMENT OF THE PARTS
Most of the cooker's parts are easy to re-
move with a simple screwdriver. In case of
accessories or spare parts inquiry, do not
forget to quote the serial number of the
er. Seldom, it is necessary to clean the glass
of the lamp cover. To make this, you have
to unscrew the lamp cover, remove the ex-
ternal residuals due to the cooking steams,
wash the lamp cover and once it is dry you
can screw it in its place.
starting the cleaning, be sure that the lamp
was not turned on before because hot lamp
is very weak.
cooker written on the warranty card or in
the identity plate: this is located in the up-
per part of the clog (you can see it removing
the wood box).
62