Rizzoli S 60 CF Manuel D'utilisation page 63

lution for stainless steel in case of hard to re-
move dirt. Do not use at all abrasive sponges
that may scratch the surface. Dry with a soft
rag, following the glazing wise.
For enamelled or painted parts, do not use
4.5 CLEANING OF THE GLASSES
The glasses of oven and fire doors may be
washed with normal products in commerce.
The internal part of the fire door has been
made to clean itself during the use of the
cooker. Anyway, sometimes you could have
WARNING! do not clean the door before waiting for his cooling. Sudden
changes in temperature may cause the breaking of the glass.
4.6 WOOD BOX
To remove the wood box you should extract
it completely, then lift it up a little and pull
it out at the same time. In this way you ac-
WARNING! do not put inflammable products inside the wood box! The ob-
jects inside the wood box must not reach the upper wall of the wood box.
4.7 PLATE CLEANING AND MAINTENANCE
Radiating plates in special steel need regular
maintenance, in particular they need clean-
ing after every use that brings moisture or
dust on the plate itself. You should clean the
plate when it is tepid, so that the moisture
vanish for evaporation and rust stains do
not occur.
Do not clean the cooker with water when
the cooker is cold. Moreover, it is important
to be sure that the expansion cuts and the
hole between the plate and the frame are
not obstructed by dust or by other residu-
als: the plate could suffer deformations, also
permanent. When it is necessary, you should
clean also the beating of the circled remov-
ing eventual residuals. The plates are all
worked in with non acid anti-corrosion oil.
The use of the cooker deletes this oil layer
and so the contact with water may cause
small rusty stains. In this case you have to
abrasive or aggressive solution and in case
of stains pour some oil and wait while it ab-
sorbs the halo. Do not use aggressive or acid
detersives.
to clean this part also. For this, you have to
remove the internal glass unscrewing the 4
screws that block it.
cess to the lower part of the cooker. To re-
insert the wood box you can make the same
process reversed.
wipe the plate with a rag soaked with
non acid oil. If the rusty stain is not being
cleaned, you could have to wipe the plate
with a lightly abrasive paper or with the
abrasive sponge given together with the
cooker. To restore the protecting layer wipe
the plate with little oil.
Radiating steel plates, exposed to continu-
ous heating, trend slowly to take a bur-
nished colour; if you want to accelerate the
process, repeat frequently the oil wiping.
Together with the cooker are given two ex-
clusive products, studied for the cleaning
and the maintenance of the plate: on how
to use them please read the instructions
written on the bottles.
To remove the plate, you have to lift it up.
When you reinsert the plate, keep in mind
to leave the 1 or 2 millimetres to allow the
thermal expansion of the plate itself.
61