Rizzoli S 60 CF Manuel D'utilisation page 55

Picture 9 - Position of the terminal board for the con-
nection to AC power.
2.8 HANDRAIL PREDISPOSITION
S 80 and S 90 cookers are endowed with
30 mm
handrail on three sides (front, left side, right
side). In some situations it may be necessary
to remove the handrail from one or more si-
des. To make this operation, you need a star
screwdriver and the hex key with the screws
given together with the cooker. First, you
must remove the final part, which is just in-
serted by pressure. Then you have to release
the hex head screws under the carrying of
the handrail where necessary. Now you can
extract the handrail bar from the carryings,
then unthread the pommels of the carryings
and the bend of the handrail.
2 mm
Picture 11a - Modification of the handrail
1
2
3
Picure 10 - Electric terminal board for the connection to
AC power: 1.Line 2.Neutral 3.Earth
Now you must insert the final part where
was inserted the bend before, then remove
the carryings with the star screwdriver, re-
place the fixing screws with the screws gi-
ven as endowment and finally close again
the hex head screws released before. S 60
CF and S 60 SF are endowed with the fron-
tal handrail only. It is possible to request the
accessories to add the handrail to one or
both sides. To make this operation you must
release the two screws on the lateral bor-
der of the top, then add the two carryings
fixing these with the special screws. Now,
remove the final part from the side in which
53