Footrests - Puky Ceety Notice D'utilisation

– Replace the two clips in the loops of the
belts (Fig. 17, A).
– Then attach the corresponding padding
loops to the clips (Fig. 17, B).
– Working from the front, pull the two belts so
that the clips are pulled into the recesses
in the backrest where they are fi rmly held
(Fig. 18, A and B).
– Push the backrest forward, pull the back
padding over the backrest and align
(Fig. 19).
– Place the backrest in an upright position
and lock it with the red fastener at the back
(Fig. 20, A).
– Finally, fi rmly pull the two belts to make
sure they are secure.
Attaching Shoulder Bag
– Undo the Velcro fastener at the back of the
shoulder bag.
– Place the retaining tabs around the two
tubes of the push-bar and fasten the Velcro
fastener (Fig. 21).
Adjusting Seat Position
You can slide the seat mount together with the
mounted seat on the frame to adjust the seat
position to the size of the child. In this way you
set the correct distance of the seat to the han-
dlebars while also setting the optimum height.
– Undo the screw connection under the seat
by fi rmly holding the screw with the sup-
plied open-ended spanner on the one side
and releasing the nut with another 10 mm
open-ended spanner on the other side
(Fig. 22, A and B).
– Slide the seat to the required position
(Fig. 23) and retighten the screw connec-
tion (5 to 8 Nm). Make sure that no parts of
the seat belt are trapped.

Footrests

Mount the footrests as described in the sepa-
rate assembly instructions.
Final Check
After assembly, always check that all screws
are fi rmly tightened and mounted parts are
secure. Make sure that all parts have been
assembled and no material (screws and nuts)
is left over.
Disposing of Packaging
Dispose of the packaging and protective
material at the local collection and recycling
centres. The material does not belong in the
household waste.
22