Puky Ceety Notice D'utilisation page 22

Mounting Handlebar
– Align the handlebar such that the PUKY
logo on the protective padding faces for-
ward (Fig. 5, A).
– Slide the handlebar from above on to the
handlebar stem and fi rmly press down as
far as it will go.
– Use the Allan key to tighten (5 to 8 Nm) the
screw in the clamp (Fig. 5, B).
– Then slide the protective cap back over the
clamp so that it snaps in (Fig. 6, A).
Fitting Push-Bar
– Extend the push-bar until the snap-in stud
engages in one of the three holes on the
right-hand side (Fig. 7, A).
– Release the red lever on the frame under
the seat mount and hold it in the up posi-
tion (Fig. 7, B).
– Align the push-bar so that the snap-in
stud on the lower end points backwards
(Fig. 8, A).
– Insert the push-bar as far as it will go into
the holder. The snap-in stud fi ts through the
recess in the holder and snaps in below the
lever.
– Push down the red lever to lock the push-
bar.
Fitting Storage Tray
The carrier net is already fi xed to the storage
tray.
– With the narrow end facing forward, slide
the storage tray over the rear axle and un-
der the seat mount (Fig. 9).
– Firmly press down the tray at the level of
the axle to snap it on to the rear axle.
– Lock the storage tray in position by press-
ing down the rear section so that the latch
snaps into the hook under the seat mount
(Fig. 10, A). To do so, you may have to
open the hook a little with the other hand.
– Attach the two loops of the carrier net to
the hooks on the push-bar.
Mounting Seat
The seat moulding is already integrated and
fi xed in the seat padding.
– Remove the two screws from the seat
mount on the frame.
– Place the seat on the seat mount.
– Unfasten the seat belt buckle. To do so,
press the bottom end of the buckle with
one hand (Fig. 11, A) and press the two
red locking buttons with the other hand
(Fig. 11, B).
20