Nice AVIO500 Instructions Et Avertissements Pour L'installation Et L'utilisation page 33

3.3 - INSTALLATION OF OTHER EQUIPMENT
The AVIO500 installation is made up of three parts:
- Guide assembly (see paragraph 3.3.1).
- Fixing of the gearmotor to the guide (see paragraph 3.3.2).
- Fixing of the gearmotor to the ceiling (see paragraph 3.3.3).
3.3.1 – ssem ling t e guide
The guide supplied with the AVIO500 must be assembled as follows:
1. Referring to figure 14, remove the belt tensioner device (14a); insert
one end of the belt into the pulley (14b); reintroduce the belt tensioner
device into the guide (14c).
14a
1
3
2
2. Pass the same end of the belt through the head [A], as in figure 15.
NB - Make sure that the belt is correctly positioned: it must be with
the teeth facing inwards, straight and without twists.
15
3. Turn the lower section of the carriage so that the grooves correspond
ith the t o ends of the belt, as in figure 16.
16
4. Place both ends of the belt into all the shaped slots of the lower car-
riage [B]. Secure the ends of the belt with the 2 screws (V4.2x9.5)
and 2 ashers (R05), as in figure 17.
17
5. Fix the belt guide [C] to the upper carriage [D] with the V6x18 screw
and related M6 nut, as in figure 18.
18
8 – English
14b
4
14c
A
B
D
C
6. Insert the upper carriage [D] into the lower carriage [B] and place the
entire carriage assembly inside the guide, as in figue 19.
19
7. With the aid of a hammer, assemble the three pieces of the guide
engaging them into the connection brackets [E], using the hammer,
per figures 20 and 21.
m ortant – the guides must slide inside the brackets until they click
firmly into place.
20
E
8. Carefully position the belt into the guide, making sure that it is not twisted.
9. Fix the head [A] into the free end of the guide ith force, as in figure 22.
22
10. Finally, tension the belt with the adjustment screw [F] of the belt ten-
sioner device. See fig. 23.
Caution - the gearmotor could break if the belt is TAUT, and it
could cause unpleasant noise if it is too SLACK.
23
3.3.2 – i ing t e gearmotor to t e guide
1 Couple the AVIO500 gearmotor's shaft extension with the head of the
guide [A]; then secure them using the four M6.3x38 screws [G].
24
G
D
B
21
A
F
A