Manitowoc QF0400 Manuel D'installation, D'utilisation Et D'entretien page 16

Maintenance
Float Valve Removal
1. Place the toggle switch in the OFF position, turn off
the water supply and disconnect electrical power to
the ice machine.
2. Disconnect water supply line at float valve quick
disconnect by depressing stainless steel lever.
3. Remove water float valve coil.
4. Depress coil and rotate 1/4 turn counterclockwise.
5. With coil wires attached, lift coil off enclosure tube.
6. Remove top cover from float reservoir.
7. Lift float valve out of float reservoir.
PULL UP ON WATER LEVEL PROBES TO REMOVE -
CLEAN IN PLACE OR DISCONNECT WIRES
DEPRESS AND TWIST
COIL 1/4 TURN, THEN
LIFT TO REMOVE
DEPRESS TAB TO
REMOVE WATER
INLET LINE
16
Bin Door Removal
Door removal allows easier access for cleaning and
sanitizing.
1. Disconnect the electrical power to the ice machine
and remove ice from bin.
2. Grasp the rear of the bin door and pull bin door
forward approximately 5" (13 cm).
3. Slide bin door to the rear while applying upward
pressure (the rear door pins will ride up into the track
slot).
4. Slide the rear door pins off the end and then below
the door track. Slide bin door forward allowing the
back of the door to lower into the bin. Continue
forward with the bin door until the front pins bottom
out in the track.
5. Lift the right side of the bin door until the front pin
clears the track.
6. Remove door from bin.
Press Down to
Release Door
Track Slot
Section 4
Slide Door Forward
Part Number 000007651 05/10