Operating The Device; Power Supply; Switching The Device On And Off; Display - Hoyer SKMK 1200 A1 Mode D'emploi

5. Add the new object to be weighed to
the existing object to be weighed.
On the display 25 the weight of the
added object to be weighed is shown in
grams.
6. Repeat the procedure with an additional
object to be weighed or remove the ob-
ject to be weighed from the scale 14.
7. Press one of the program buttons or se-
lect a time or temperature to end the
weighing function.
NOTE: if too much weight is put on the
scale, - - - - appears on the display.

9. Operating the device

For safety reasons, the settings described in
this chapter, can only be selected when the
device has been assembled completely.

9.1 Power supply

• First, connect the power cable 7 to the
mains power socket 8 of the base unit 12
and then plug the mains plug 7 into a suit-
able wall socket. The wall socket must con-
tinue to be easily accessible after the
device is plugged in.
9.2 Switching the device on
and off
• Set the main switch 6 on the rear to I:
- All buttons light up briefly.
- The display 25 is lit and briefly
shows a control display. Then the con-
trol symbols are displayed. All adjust-
able values are set to 0.
TEMPS
TEMP.
VITESSE
- An acoustic signal sounds.
• Set the main switch 6 on the rear to 0
to switch the device off.

9.3 Display

The display 25 shows all settings and oper-
ating values.
After approx. 5 minutes, the illumination of
the display 25 goes off. As soon as any but-
ton is pressed or a control is turned, the illu-
mination of the display 25 is switched on
again for 5 minutes.
113
GB