Application Conditions - Burkert 6213 EV Manuel D'utilisation

Application conditions

6.1.
Allowable temperatures
Ambient temperature: Max. +55 °C
Permitted medium temperature depending on coil and seal
material:
Coil housing Seal material
Polyamide FKM
Epoxy (NA38) FKM
Epoxy (NA38) EPDM
Polyamide NBR
Permitted media depending on seal material:
Seal material Permitted media
Per-solutions, hot oils without additives,
FKM diesel and heating oil without additives,
detergent solution
Oil and grease-free liquids, cold and hot
EPDM
water
NBR Cold and warm water
Gaseous media at low differential pressures (e.g. compressed
1
air and vacuum) can also be actuated in consideration (or due
to restriction) of a lower tightness. We recommend prior clarifi-
cation with our sales office regarding the possible application.
English
12
6.3. rating plate description
Example:
Housing material
Seal material
Orifice
Operating principle
Type
6213EV A 10 EPDM MS
G3/8 P N0 - 10bar
230V 50Hz
00206691
Article number
Manufacturer code
Voltage, frequency,
power consumption
Connection thread, nominal pressure
English
14
Medium temperature
0 – +90 °C
0 – +120 °C
-30 – +120 °C
-10 – +80 °C
1
8W
W14 LU
Operating duration
Unless otherwise indicated on the rating plate, the solenoid
system is suitable for continuous operation.
Important information for functional reliability during
continuous operation!
If switched on for a long period, it is recommended
to activate the valve 1-2 per day.
Service life
High switching frequency and high pressures reduce the
service life.
6.2. conformity
CE mark conforms to EMC Directive 2004/108/EC
(only if cables, plugs and sockets connected correctly).
7. insTallaTiOn
7.1. safety instructions
Danger!
Risk of injury from high pressure in the equipment!
• Before loosening the pipes and valves, turn off the
pressure and vent the pipes.
Risk of injury due to electrical shock!
• Before reaching into the device or the equipment,
switch off the power supply and secure to prevent
reactivation!
• Observe applicable accident prevention and safety
regulations for electrical equipment!
Warning!
Risk of injury from improper installation!
• Installation may be carried out by authorized techni-
cians only and with the appropriate tools!
Risk of injury from unintentional activation of the
system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
Type 6213 EV
English
13 13
English
15 15