Ecolab My Control Manuel D'utilisation page 161

7.2.4.3.2 Main Equipment
Fig. 52: Configuration -> Equipment -> Main Equipment
Select the Main Equipment
Main equipment parameters:
n ME: define which equipment you have
n Dosing line: which line is concerned
n FM Cal.: flow meter calibration
n FM Max t.: flow meter max time
n FS delay: Flow switch delay
n ME Type: 1=Desamix; 2=Compactomix; 3=Solumix; 0=not used
n Pre flush time: rinsing before dosing
n Flush pump time: rinsing time
n St Night flush: inactivate time of the system
n Night flush time: time
Selection and activation of each push button in green
n
n No selection and no activation if each push button in grey
n Flowmeter enable: selection have to be done
n Flowswitch enable: selection have to be done
n Flowmeter / Flowswitch activated: validation of the selection
n Low level alarm: activation low level on the selected pump
n Weight control dosage: dosing depending of the real or therotical weight
Pump dose alone: pump running always alone on this dosing line. Flush while dosing:
dosing and rinsing in the same time. Leakage alarm: dosing pulses detected when dosing
equipment stopped.
Available Menue:
Back to Equipment:
see chapter Ä Chapter 7.2.4.3 'Equipment' on page 61.
Back to Main Screen:
Ä Chapter 7.2 'System Start - Main Screen' on page 34.
see chapter
63
Software description
417101971 Rev. 2-02.2019