Ecolab My Control Manuel D'utilisation page 152

Software description
7.2.4.2.2 Tunnel 1 & 2
Fig. 42: Configuration -> Machine -> WE -> WE Parameters
Select the Tunnel
Selection Tunnel number.
Tunnel parameters:
n Maximum load: therotical weight of the WE (only used to limitate the quantity of
product)
n Minimum load: therotical weight of the WE (only used to limitate the quantity of
product)
n Prog nb empty compart: to allocate prg of ≠ 0 for the empty compartment
n Nb of compart. TUN: How many module Tunnel had
n Nb of compartment conveyer belt: how many compartments in conveyor belt
Choice on any push button to go in the request mode
n
Tunnel mode:
n Mode 1: Program = Binary, Transfer conveyor = Transfer Tunnel
n Mode 2: Program = Miniterminal, Transfer conveyor = Miniterminal
n Mode 3: Program = Binary, Transfer conveyor = Dedicated input
n Mode 4: Program = Miniterminal, Transfer conveyor = Transfer Tunnel
n Mode 5: Program = Miniterminal, Transfer conveyor = Dedicated input
Ext. Clock / Data prot. = New kannegiesser protocol (65 bits), Prog by time: 1s = prg 1.
Weight by time: 1s = 1 Kg
Weight by ana.I: weight information on analog input
T.O.M. mode: Time Out of Machine
Sig Stop act. : signal authorization to be able to stop the tunnel
Sig. Eject act. : signal authorization of ejection
Delay x 10s: time delay for all programs x 10
Weight corr.: weight compensation 1 batch on 2 = +1Kg
Kan.Press mode: injection in the Kannegiesser Press desynchronized
Ext clock/data prot. : New protocol "clock – Data" from Kannegiesser with a higher
frequency and more information.
Available Menue:
Back to Configuration:
Ä Chapter 7.2.4 'Configuration level access' on page 45.
see chapter
Back to Main Screen:
see chapter Ä Chapter 7.2 'System Start - Main Screen' on page 34.
417101971 Rev. 2-02.2019 54