Navigating Within A Menu; Using The Alphanumeric Keypad; Alphanumeric Input - Mettler Toledo SevenCompact S230 Conductivity Mode D'emploi

3 Press to highlight Sensor ID / SN.
4 Press EXIT to return to the measurement screen.
4.7 N avigating within a menu
This example is based on the Setup menu, but the procedure applies to the other menus as well.
●
Press Menu.
The Setup menu appears and the Cond. tab is highlighted.
●
Press as often as needed to navigate to a menu item.
●
Press Select to move deeper in the menu for the chosen operation.
●
Continue navigating with
the menu.
●
Press MODE/EXIT to go back to the previous menu.
— or —
●
Press READ to return to the measurement screen directly.
4.8 U sing the alphanumeric keypad
4.8.1 A lphanumeric input
The meter has a screen keypad for entering IDs, SNs and PINs. Both numbers and letters are al-
lowed for these entries.
When entering a PIN, each character entered will be displayed as ( * ).
1 Press to move left to highlight number or letter, use
move downwards.
2 Press READ to confirm the entry.
The line where the position of alphanumeric character is being entered blinks.
3 To end and confirm entry, use softkeys to highlight screen key OK, and press READ to save
the ID.
— or —
4 To delete information, use softkeys to highlight
entered character.
— or —
, or Select until the final destination is reached within
and press READ to delete the previously
to move right, and
Operating the meter
to
17