Setup; Menu Structure Of Setup; Sample Id; User Id - Mettler Toledo SevenCompact S230 Conductivity Mode D'emploi

5 S etup
5.1 M enu structure of setup
The individual items of the menu setup are described on the pages following the list below.
1. Sample ID
1. Enter Sample ID
2. Select Sample ID
3. Delete Sample ID
2. User ID
1. Enter User ID
2. Select User ID
3. Delete User ID
3. Stirrer
1. Stir Before Measurement
2. Stir During Measurement
3. Stir Speed
4. Stirrer Voltage Settings
4. Data Transfer Settings
1. Data Logging
2. Interface
3. Printout Format
5.2 S ample ID
An alphanumeric sample ID with up to 16 characters can be entered. Alternatively, a previously
entered sample ID can be selected from the list. If a sample ID has been entered, which is either
pure l y numeric (for example, 123) or ends with a number (for example, WATER123), the fol l ow-
ing options are available:
1. <Auto Sequential> On
Using this setting will automatically increment the sample ID by 1 for each reading.
2. <Auto Sequential> Off
The sample ID is not incremented automatically.
A maximum of 10 sample IDs are stored in memory and listed for selection. If the maximum of 10
has already been entered, a sample ID can either be deleted manually or the oldest ID will be auto-
mat i c al l y overwritten by the new ID.
This instrument allows a special process for users that would like to enter the sample ID in a
quick e r way. When the homescreen is shown, while no measurement or calibration is running,
typ i ng on a USB-keyboard or scanning with a barcode reader, results in a jump in the sample ID
entry screen and the entered characters are shown. In case a character is entered or scanned that
is not present on the instrument keyboard (see "Operating the meter: Entering IDs/PIN"). It will dis-
play the entry as an underscore (_).
5.3 U ser ID
A user ID with up to 16 characters can be entered. Alternatively, a previously entered user ID can
be selected from the list.
5. System settings
1. Language
2. Time and Date
3. Access Control
4. Beep
5. Routine/Expert Mode
6. Screen Settings
6. Service
1. Software Update
2. Export Settings to USB-stick
3. Factory Reset
7. Instrument Self-test

Setup

21