9. Do not store or use the device:
- in places where it can get wet or fall into water
- in the vicinity of highly flammable, explosive or gaseous substances. A
spark from the switch could ignite it.
- in the vicinity of acids, alkalis, oil and other substances that can cause
corrosion.
10. Always place the device on a dry, stable, horizontal and even surface.
11. Do not place the device directly beneath a wall socket.
12. Do not place objects on the device or sit on them.
13. Make sure the air supply and air vent are not affected by blockages. Do
not place anything on or over the device and do not place the unit too
close to walls, curtains, furniture etc. Obstruction of the air supply and
air vent can affect the operation and service life!
14. Keep the intake and discharge grilles clean and free of dust and ensure
a minimum clearance of 30 to 50 cm around the appliance.
15. Do not touch the unit, move/reposition it or hold it at an angle once
you have filled it with water; and prevent moisture in the electrical part.
If you accidentally end up with water in the electrical part, remove the
plug from the socket immediately and remove as much of the water as
you can. Leave the unit to dry out for at least 24 hours. Keep a close eye
on the device when you want to start using it again. If you determine
that it is working or sounding abnormal, immediately pull the plug out
of the socket and have the device checked / repaired by a qualified
electrician.
16. Replace the water regularly, especially in case of warm weather, to
prevent contamination. Remove the remaining water from the unit
during frosty conditions!
17. Do not exceed the 'MAX' level when refilling the water reservoir; For
'cooling', the water must be above the 'MIN' level. Ensure that the
plug does not get wet or fall into the water tank. Never use the cooling
function without sufficient water in the water tank. Only use cold water,
no lukewarm of hot water.
18. Do not use the 'cool' function in a small, enclosed space.
19. Always remove the plug from the socket when the unit is not in use.
2 0