FUAVE ACC06K02 Livret D'instructions page 22

SAFETY NOTICE
1. Before using the device carefully read this entire instruction manual.
2. Before using your new device, check it, including cord and plug, for any
visible damage. Do not use a damaged unit, but send it back to your
dealer for replacement.
3. Remove the plug from the socket and immediately switch the appliance
off when there is a strange noise, smell or smoke.
4. This equipment is strictly intended for normal domestic use, indoors.
Use this appliance only for the purpose for which it was designed
(cooling / ventilating a domestic room) and in the manner described in
this manual.
5. This device in not suitable for use in wet or damp spaces such as
bathrooms and laundry rooms. Do not place the device in the vicinity
of taps, bathtub, shower, pool, fountains or other sources of moisture.
Make sure it cannot fall into water and prevent water from getting into
the device itself. If, at any time, the device does fall into water, unplug
it immediately! Do not use a device that has a damp interior but have
it repaired. Never immerse the device, cord or plug in water and never
touch it with wet hands.
6. The supply voltage and utility frequency (220-240V~50Hz), specified
on the machine, need to match those of the socket that is used. The
electrical installation needs to be protected by a residual current device
(max. 30 mA).
7. Fully extend the cord before plugging in the heater. Prevent it from
heating up any way. Do not run the cord underneath carpeting; do not
cover it with mats, carpet strips, or similar and make sure it is not placed
in any passageways. Make sure the cord cannot be stepped on and that
no furniture is placed on top of it. Do not lead the cord around sharp
corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord. If the use of an extension cord
is unavoidable, then make sure it is an undamaged, approved extension
cord with enough. To prevent overheating, always fully extend the cord!
1 9