Description Of Display; Status Bar (Sector S); Wiz (Sector I) - Cebora 553 Manuel D'instructions

4

DESCRIPTION OF DISPLAY

♦ To select sectors, press and release knob B so that a sector is highlighted in red. Turn knob B
to select the desired sector, and then briefl y press knob B to access the settings of the selected
sector.
♦ The most recent setting is highlighted in green, and boxed in red. When you turn knob B, the red
box moves to the newly selected sector.
Give knob B a quick press when this symbol is selected to go back to the previous screen.
Select and confi rm this symbol to set the factory parameters of the parameter displayed.
IMPORTANT
To return to the main screen from any condition, press and hold knob B (> 0.7 sec.)
4.1

Status bar (sector S)

This sector is positioned on the upper part of the display. It provides in summary form the welding and cooling unit
settings, block and other functions.
Only for Item No 558, when the green light (< 48 V) is on, the effi ciency of the no-load voltage in AC welding processes
is displayed.
4.2

WIZ (Sector I)

see section 7.1
3301230/A
During start-up, for 5 seconds the display presents all the information
regarding the welding machine software versions.
The display then presents the main screen (factory setting). The
operator may start welding immediately and may adjust the current
by turning knob B.
As shown in the fi gure, the display is subdivided into sectors. Each
sector allows you to set the desired operating mode.
57/89