Instruction Manual For Cooling Unit; Safety Regulations; General Description - Cebora GRV 12 Manuel D'instructions

INSTRUCTION MANUAL FOR COOLING UNIT

IMPORTANT:
YOU ARE ADVISED TO READ THIS MANUAL, PAYING PARTICULAR ATTENTION TO THE SAFETY REGULATIONS,
BEFORE INSTALLING, USING OR CARRYING OUT ANY MAINTENANCE ON THE UNIT.
IF YOU DO NOT FULLY UNDERSTAND THESE INSTRUCTIONS, CONTACT YOUR SUPPLIER.
1

SAFETY REGULATIONS

1.1 Introduction
Before use, all persons authorized to operate, repair or inspect the unit must read the following safety and operating
instructions.
For more detailed information, please refer to the general warnings manual code 3301151
2

GENERAL DESCRIPTION

2.1 Specifications
This apparatus is a self-contained cooling unit, designed to cool the torches used in TIG, MIG, MAG welding and
plasma cutting equipments.
2.2 Explanation of technical data
N° Serial number which must be stated for any demands
relating to the machine
U1 Rated supply voltage
1x - V Single-phase power supply
50/60 Hz Frequency
I1 Maximum input current
IP23 Grade of protection of the body
2.3 Description of protections
2.3.1 Electric protection.
The cooling unit is protected against overload by means of a fuse.
2.3.2 "Coolant pressure" protection
This protection is created by a pressure switch, fitted on the coolant delivery circuit, which controls a microswitch
fitted.
N.B.: To use this protection, connector (E) must be inserted in the welding or cutting generator's special socket.
3300948/C 5/7