Necessary Tools; Tab Installation - Ultraflex UFLEX MTT12 Manuel D'installation Et D'entretien

3 INSTALLATION

3.1 Necessary tools

Drill
Hole saw Ø70mm
(2.75")

3.2 Tab installation

1 Find the tab installation point as shown in the picture.
WARNING
Make sure the upper fixing bracket (A) of the actuator is not near other devices in the inner part of the
transom obstructing the passage of the power cable.
Place the tab hinge at a minimum distance of 200mm (8") from the boat center line, at 25-100mm (1-4")
from the side edge of the keel and at 10mm (3/8") from the bottom part of the hull. If there are some
steps in the bottom part of the boat, the hinge must be positioned at a distance of at least 50mm (2")
from the top of the fairing.
Make sure the hinge is parallel to the bottom part of the hull. Moreover, for a correct installation, the
side corner of the hinge must be at a minimum distance of 50mm (2") from the fairing.
Pliers Tape measure
Cutter
Installation and maintenance manual
Drill bits
Ø4,5mm (0.18")
Ø10mm (0.394")
Phillips
Ruler
screwdriver
ELECTROMECHANICAL TRIM TABS
Hammer
Open end
wrench
10mm (0.39")
Sealant 3M 5200
page 11
- of 83