Minimum Transom Requirements; Necessary Tools - Ultraflex UC 95-OBF Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Minimum transom requirements

The following picture shows the minimum splash well dimensions. These dimensions must be respected in
order to prevent the cylinder from being damaged when the outboard engine is completely tilted upwards. The
picture shows also the minimum transom dimensions, needed for the installation and the correct operation of
the engine steering cylinder.
Engine No.
1
2
WARNING
ENGINE JACK PLATE APPLICATION TO THE TRANSOM.
A jack plate installation will change all the application clearances. A new clearance check must be completed with
the tilting of the engine in conjunction with the vertical movement of the jack plate in all the possible positions.
If the steering cylinder comes into contact with the splash well, transom and/or jack plate, stop the installation
immediately! Use the jack plate manufacturer's instructions to limit the upper or lower direction in which the
interference occurs. If this is not possible please contact specialized staff.

3.2 Necessary tools

Allen wrench Open end wrench
4 mm [5/32"] 3/4''
CAUTION
During installation use only stainless steel tools to prevent the corrosion of the metal parts.
C
MINIMUM SPLASH WELL DIMENSION REQUIREMENTS MINIMUM SPLASH WELL DIMENSION REQUIREMENTS
A
560 mm - 21.25"
1110 mm - 43.70"
Open end wrench
Open end wrench
11/16"
14mm
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
A
B
305 mm - 12" 152 mm - 5.98"
305 mm - 12" 152 mm - 5.98"
Pliers
Open end wrench
5/8"
C
Torque wrench MOLYKOTE® 1000
page 11
- of 79