Necessary Tools; Control Box Installation - Ultraflex B110B Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Necessary tools

Phillips
screwdriver
(Ø6)

3.2 Control box installation

NOTICE
Depending on the control cables, it is possible to mount
the mechanism in horizontal or vertical position as shown
in the figures on the side, by rotating the internal
mechanism in such a way that the flange inspection hole
matches with the clutch adjustment screw of the
mechanism (see paragraph 3.9).
This consideration is also valid for lever with kill switches
models.
CAUTION
Use the "C" plugs supplied in the screw bag to close two
of the three not used inspection holes in the flange. This
is also valid for lever models with kill switches.
page 10
of 67 -
SINGLE LEVER CONTROL B110
Flathead
screwdriver (Ø2)
Installation and maintenace manual
14 mm socket
Pliers
spanner
Drill
C