Minimum Transom Requirements; Necessary Tools - Ultraflex UC 130 Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Minimum transom requirements

The following picture shows the minimum splash well dimensions. These dimensions must be respected in
order to prevent the cylinder from being damaged when the outboard engine is completely tilted upwards.
The picture shows also the minimum transom dimensions, needed for the installation and the correct
operation of the engine steering cylinder.
MINIMUM SPLASH WELL DIMENSION REQUIREMENTS
Engine No.
1
2
WARNING
ENGINE JACK PLATE APPLICATION TO THE TRANSOM.
A jack plate installation will change all the application clearances. A new clearance check must be completed
with the tilting of the engine in conjunction with the vertical movement of the jack plate in all the possible
positions. If the steering cylinder comes into contact with the splash well, transom and/or jack plate, stop
the installation immediately! Use the jack plate manufacturer's instructions to limit the upper or lower
direction in which the interference occurs. If this is not possible please contact specialized staff.

3.2 Necessary tools

A
560 mm - 21.25"
1110 mm - 43.70"
Open end
wrench
9/16"
Allen wrench
Torque wrench
[1/8"]
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
C
B
152 mm - 5.98"
152 mm - 5.98"
Open end Open end
wrench wrench
16mm 3/4"
MOLYKOTE® 1000
A
C
152 mm - 5.98"
152 mm - 5.98"
page 11
- of 83