Electric Heating For The Display Version; Gas Heating (If A Gas System Has Been Installed); Electric + Gas Heating (If A Gas System Has Been Installed); Turning The Machine Off - Astoria Core600 AL Manuel D'utilisation Et D'entretien

6.3.3 Electric heating for the DISPLAY
version
• Press the machine's main
switch (2).
• Wait another second or so for the automatic test to be
carried out.
XPV35 XXXX FW ver. 01.09
Controller Board FW ver. 1.15
• Wait for the water in the heating unit to be automatically
refilled, if this is necessary. This will be shown on the dis-
play.
48
°C
• Wait a few moments for the machine to fully heat up.
53
°C
• If the timeout intervenes, a red flashing warning will ap-
pear on the display.
USER Manual
2
Heating-up phase
The heating unit
is being filled with
water (yellow colour)
Heating-up phase
Heating unit water OK
Flashing
red colour
Flashing
yellow colour
6.3.4 Gas heating
(if a gas system has been installed)
• Turn the power switch (A) to position 1.
• Open the gas valve (B) on the mains.
• Hold down the (C) button and, at the same time, press
the ON button (D). Once the flame ignites, hold down the
knob (C) for a few seconds, to allow the thermocouple to
activate correctly.
• Then check that the flame has ignited through the win-
dow (E).
• Wait for the operating pressure shown on the pressure
gauge to reach the working value of 0.1-0.12 MPa (1-1.2
bar).
B
Electric + gas heating
6.3.5
(if a gas system has been installed)
• Proceed as indicated in the previous paragraph.
• After checking that the flame has ignited, turn the power
switch (A) to position 2. In this way the heating unit's
heating element is powered and the operating pressure
will be reached more quickly.
• Wait for the operating pressure shown on the pressure
gauge to reach the working value of 0.1-0.12 MPa (1-1.2
bar).
6.3.6

Turning the machine off

Turn off the machine using the main switch or power switch.
A D C E
45 216
of