Dispensing Of The Coffee; Aep Version; Sae - Display Version - Astoria AL Manuel D'utilisation Et D'entretien

Dispensing of the coffee

6.6
6.6.1 AL version
• Put the coffee cup under
the dispensing spout
• pull the lever all the way
down;
• wait for the short coffee
pre-infusion time (3÷5
seconds);
• lift the lever until some
resistance is felt, then
release it;
• wait until coffee delivery
is complete.
Never perform the above actions without coffee in the filter or
without the filter holder attached to the delivery group. The
rapid upward movement of the lever may cause damage to the
appliance, individuals or property.
Delivery time deepens on grinding and the amount of coffee in
the filter holder.

6.6.2 AEP version

• Put the coffee cup under the
dispensing spout
• Press the desired delivery
switch. The delivery will begin,
and it can be stopped using the
same switch once the desired
amount of coffee is obtained
in the cup.
56 260
of

6.6.3 SAE - DISPLAY version

PROGRAMMING
The machine is programmed
by default. Should coffee doses
need to be modified, proceed as
follows:
• Always programme the right-
hand push-button panel first.
In this way all push-button pan-
els get programmed automati-
cally. If necessary programme all
the others subsequently;
• Position the cup under the dis-
pensing spout;
• Press button for at least 5
PROG.
STOP
seconds until all leds of the dose
buttons are lit;
• Press the wanted dose button,
for example ;
• to confirm the dose, press but-
ton again, or button
• repeat this operation for the
other dose buttons;
• on concluding the programming, press button
until all leds of the push-button
panel are switched off.
The programming of every dose must be carried out with ground
coffee and not with previously used coffee dregs.
PROG.
STOP
PROG.
STOP
;
PROG.
PROG.
STOP
STOP
PROG.
STOP
USER manual
PROG.
STOP