Electrical Connection - aqua technix AQ 280 Traduction Du Instruction D'utilisation Originale

Installation
4.4

Electrical connection

WARNING
Risk of electric shock due to incorrect connections!
Electrical connections must always be carried out by

authorised specialists.
 Observe VDE and utility company regulations.
 Install pumps for swimming pools and their protection
according to DIN VDE 0100-702.
 Install a disconnecting device with at least a 3 mm contact
gap per pole to interrupt the power supply.
 Protect power supply with a ground fault circuit interrupter,
nominal residual current I
 Only use suitable pipe types according to regional
regulations.
 Adjust minimum diameter of the electrical pipes to
accommodate the motor output and pipe length.
 If hazardous situations can occur, provide an emergency off
switch according to DIN EN 809. The builder/operator must
make a decision according to this standard.
20 EN
≤ 30 mA.
FN
06|2019