Commissioning; Checking How Easily The Pump Rotates; Filling With Water - aqua technix AQ 280 Traduction Du Instruction D'utilisation Originale

5

Commissioning

NOTICE
The pump can be damaged if it runs dry!
 Ensure that the pump is always full of water.
5.1

Checking how easily the pump rotates

After longer idle periods, the pump must be checked for how
easily it rotates while it is switched off.
Place a screwdriver in the groove on the end of the motor

shaft on the fan side and turn it.
5.2

Filling with water

System
Below the
water level
Above the
water level
With
suspended
skimmer
NOTICE
High cp.oncentrations of water treatment chemicals can damage
the filter system!
Do not place water treatment products, particularly in tablet

form, into the strainer basket of the pump or filter system.
06|2019
Filling with water
Open the shut-off valve at the suction and

pressure side (not included in the scope
of delivery).
Do not install the filter system more than

3 m below the pool water level.
Use self-priming pump.

 See pump operating instructions
 Fill the pump with water through the pre-
filter and screw the pump cover back on.
Ensure that the seal in the lid is not

damaged or twisted.
 Do not install the filter system more than
2 m above the water level.
 Do not connect the suction hose to the
skimmer until it is completely filled with
water.
Commissioning
EN 21