Further Measures - aqua technix AQ 280 Traduction Du Instruction D'utilisation Originale

Commissioning
NOTICE
The 6-way valve (10) may only be operated when the filter pump
(40) is switched off. Otherwise the 6-way valve (10) can be
damaged.
5.3

Further measures

Measure
Flushing the
quartz sand
Cleaning the
pre-filter
Filter -
operation
Setting the
filter time
22 EN
Explanation
The quartz sand has to be washed out when
refilling.
1. 6-way valve (10) in the "RINSE" position
 Switch the filter pump on.
2. Following the start-up of the pump, run
water into the container and sewage
system for approx. 30 sec.
3. 6-way valve (10) in the "BACKWASH"
position
 Switch the filter pump on.
4. Channel the water into the waste water
system for approx. 2 min. This ensures that
quartz sand grit does not flow into the pool
through the nozzle.
5. Finally set the valve to "RINSE" for 30 sec.
Notice:
Too much sand in the filter or too high a pump
performance can lead to losing sand via the
sewage system.
Building dirt or debris have collected in the pre-
filter.
 Clean the strainer basket of the pump
approx. 10 to 15 min after the initial start-
up.
• Set the handle of the valve to "FILTER"
 Filter is ready for mechanical water
treatment
• Switch the filter pump on.
• The operating time of the filter depends on
the pool volume, frequency of use, weather
and chemicals.
06|2019