Step 8 Install Grille Panel; Step 9 Install Door Panels - Monogram ZIC360NHLH Instructions D'installation

Installation Instructions - Flush Installation

STEP 8 INSTALL GRILLE PANEL

• Raise the grille panel to stop position.
• Loose screws on side trim behind frame. Remove
bottom trim.
Loosen
side
trim
screw
Adjust nut below spring to
accommodate panel weight
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
Raise
grille
Loosen
panel
side
trim
screw

STEP 9 INSTALL DOOR PANELS

AND CUSTOM HANDLES
• Open door to 90°. Remove the 4 Phillips head screws
from the door handle.
• Remove the handle. Retain all screws.
• Remove the 4 screws holding the trim, then lift off the
trim. Retain the screws.
• Custom handles must be used for flush installation.
The handle must be properly secured to the overlay
panel before sliding the panel into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Discard the supplied handle.
• Slide the overlay panel into the door trim.
• reinstall trim by securing with all 8 screws retained in
previous steps.
• Follow the same procedures to install the drawer
panel.
36
31-49142 Rev. 2