Customization Basics; Side Panels; Optional Accessory Kits; Refrigerator Location - Monogram ZIC360NHLH Instructions D'installation

Réfrigérateur encastré à congélateur en bas 36 po avec guide de conception
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Design Guide - Stainless Steel Installation

CUSTOMIZATION BASICS:

Framed Or Overlay Panels, Custom
Handles and Accessory Kits
Professional Style Stainless Steel Refrigerators
Stainless steel wrapped refrigerators with beveled
edges and professional style handles. These models
are shipped ready for installation.
Stainless Steel Wrapped Refrigerators
Stainless steel wrapped refrigerators with beveled
edges and tubular stainless steel handles that
coordinate with other Monogram appliances. These
models are shipped ready for installation.

Side Panels

Side panels must be used whenever the sides of the
refrigerator will be exposed.
SIDE PANELS
Side panels must be used whenever the sides of the
refrigerator will be exposed. The 1/4
panels will slip into the side case trim. Secure the
panels to the refrigerator with stick-on hook and loop
fastener strips. Order the side panels from the cabinet
manufacturer.
• Cut a notch in the top front corner as shown to allow
clearance for corner keys in the front side trim.
* Depending on
installation height.
31-49142 Rev. 2
(0.63 cm) side
"
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"

OPTIONAL ACCESSORY KITS

• ZUGPP2: For side-by-side installation of two
professional-style bottom-freezer refrigerators. This kit
provides a unified stainless steel grille panel to span
the width of two units.
• ZUGSS2: For side-by-side installation of two stainless
steel wrapped bottom-freezer refrigerators. This kit
provides a unified stainless steel grille panel to span
the width of two units.

REFRIGERATOR LOCATION

• Do not install the refrigerator where the temperature
will go below 55°F (13°C). It will not run often
enough to maintain proper temperatures.
• Do not install the refrigerator where temperatures will
go above 100°F (37°C). It will not perform properly.
• Do not install the refrigerator in a location exposed to
water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
41

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zicp360nhrhZics360nharhZics360nhdrhZics360nhbrhZipp360nhss

Table des Matières