Osmosis System; Step 3 Install Side Panels; Step 4 Anti-Tip Procedure - Monogram ZIC360NHLH Instructions D'installation

Installation Instructions - Stainless Steel Installation
STEP 2 INSTALL WATER LINE
(Cont.)
Shut off the main water supply.
Turn on the nearest faucet long enough to clear the
line of water.
• Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
• Turn on the main water supply and flush debris.
Run about a quart of water through the tubing into a
bucket. Shut off water supply at the shut-off valve.
NOTE: Saddle type shut-off valves are included in
many water supply kits, but are not recommended for
this application.
NOTE: Commonwealth of Massachusetts Plumbing
Codes 248CMR shall be adhered to. Saddle
valves are illegal and use is not permitted in
Massachusetts. Consult with your licensed plumber.
STEP 2A WATER LINE
INSTALLATION WITH A REVERSE

OSMOSIS SYSTEM

Skip this step when not using an RO System
If the water supply to the refrigerator is from a Reverse
Osmosis Water System, use the refrigerator's filter
bypass plug. Using the refrigerator's water filtration
cartridge with the RO filter can result in hollow ice
cubes.
Filter Bypass Plug

STEP 3 INSTALL SIDE PANELS

Skip this step when not using side panels.
If you are using 1/4" (0.63 cm) side panels, they should
be inserted into the case trim. Fasten the panels to the
refrigerator with stick-on hook and loop fastener strips
before setting refrigerator in place.
31-49142 Rev. 2

STEP 4 ANTI-TIP PROCEDURE

WARNING
These refrigerators are top heavy, especially with any
doors open, and must be secured to prevent tipping
forward which could result in death or serious injury.
Read and follow the entire installation instructions for
securing the refrigerator with the anti-tip system.
AVERTISSEMENT
basculement Ces réfrigérateurs présentent une
partie supérieure lourde, en particulier avec une
porte ouverte; ils doivent donc être fixés pour
prévenir le basculement vers l'avant et le risque
concomitant de blessure grave ou fatale. Lisez et
suivez les instructions d'installation complètes pour
l'installation du système anti-basculement.
ADVERTENCIA
Estos refrigeradores son inestables, especialmente
cuando una puerta se encuentre abierta, y deberán estar
asegurados a fin de evitar caídas hacia adelante que
podrían resultar en la muerte o en lesiones graves. Lea y
siga las instrucciones de instalación en su totalidad para
asegurar el refrigerador con el sistema anti volcaduras.
• The kit supplied with the unit contains 2 lag bolts and
4 toggles with bolts. The wall bracket will be attached
to the wall in 4 places.
• Measure the opening where the unit is to be installed.
Mark the center with a vertical line.
• Measure up 81 1/2" (207.01 cm) from the floor. Mark
this point
on the wall.
• Using
a level,
draw a
horizontal
line on the
wall at this
height.
• Locate
at least 2
studs on
the back
wall. Mark
these
points
on the
horizontal
line.
45
Tip Over Hazard.
Risque de
Riesgo de Caídas